HR-10 Ham-Band Receiver 

Designed to match the DX-60

Amateur band coverage only (80 through 10 meters) for high stability & tuning accuracy

Tunes SSB, AM and CW

Large, slide-rule tuning dial-over 6" of bandspread

Tunable RF stage for extra sensitivity

Prebuilt, preset coil /bandswitch assembly

Lattice-type crystal filter for high selectivity


This handsomely-styled amateur receiver is a perfect match for the DX-60 Transmitter
(opposite page), providing complete high-performance station receiver facilities at low cost!
The HR-10 is designed for amateur band coverage only on 80 through 10 meters, for maximum
accuracy and stability. Each band is separately calibrated on a large, easy-to-read slide-rule
dial. The tuning dial is illuminated and provides over 6" of bandspread for precise frequency
settings. A carefully-designed diode detector, plus BFO, tunes AM or CW and SSB signals.
The 7-tube superheterodyne circuit features an RF stage for added sensitivity and employs
a half-lattice crystal filter for excellent selectivity characteristics ... a necessity 
with today's crowded band conditions. Two IF amplifiers operating at 1680 kc provide good
image rejection.

Other features include: "S" meter to aid in tuning and determining relative strength of
received signals; a 3-gang tuning capacitor to assure proper tracking of all circuits
rather than "Broad Banding"; a front panel dial calibration control and provision for
a plug-in 100 kc crystal calibrator (see HRA-10-1 below) to provide accurate dial
calibration at any 100 kc point across the band.

Other panel controls consist of: antenna trimmer, bandswitch, tuning, BFO tuning,
RF gain, AF gain w /AC on-off switch, xtal. calibration on off, STBY /RCV, BFO on/off,
AVC on off, and automatic noise limiter on /off. An accessory socket is provided on the
rear chassis apron for receiver muting, etc., and a speaker jack is provided for use
with any 8 ohm PM speaker.

21  lbs.

Kit HR-10 ... NO MONEY DOWN, $9 mo ....................... $82.95
Kit HRA-10.1, Plug-in 100 kc Crystal Calibrator, 1 lb.......$8.95

(Data Collected and Verified by KB9JJA 12-04-1997)