DX-40: Low cost Phone / CW Transmitter DX-40 PHONE AND CW TRANSMITTER KIT (DX-40) 75 Watts CW-40 Watts Phone Single Knob Bandswitching Built-in Modulator and Power Supplies An outstanding buy in its power class, the DX-40 provides both phone and CW operation on 80 through 10 meters. A single 6146 tube is used in the final amplifier stage to provide full 75 watt plate power input on CW or controlled carrier modulation peaks up to 60 watts for phone operation. Modulator and power supplies are built-in and single-knob bandswitching is combined with the pi network output circuit for complete operating convenience. A high quality D'Arsonval movement panel meter is used to indicate the final grid or plate current. A line filter and liberal shielding provides high stability and minimizes television interference. The 5-position function switch provides a "tune" position, allowing you to tune the oscillator with the final amplifier off preventing damage to the final amplifier tube. Provision is made for three crystals easily reached through a "trap door" in the back of the cabinet. A 4-position switch selects any of the three crystals or a jack for external VFO. The Heathkit Model VF-I VFO (variable frequency oscillator) can be used in place of crystals. Power for the VFO is available on the rear apron of the chassis. You can build this rig yourself and be proud to show it off to your fellow hams. Assembly proceeds smoothly from start to finish even for an individual who has never built electronic equipment before. Shpg. Wt. 25 lbs. SPECIFICATIONS Power Input: 75 watt CW, 60 watt peak controlled carrier phone Output Impedance: 50 to 600 ohms (non-reactive) Output coupling: Pi network Operation: Crystal-VFO, CW. Phone Band coverage 80, 40, 20,15, 10 meters Tube complement 5U4GB Rectifier 12AX7 Speech Amplifier 6DE7 Controlled Carrier, Modulator 6CL6 Crystal Oscillator 6CL6 Buffer 6146 Final Amplifier Power requirements 117 volts AC, 60 cycles, 175 watts Cabinet size 13' W. x 8 1/2' H. x 9' D. KB9JJA