Heathkit IP-17 Regulated High Voltage Power Supply

B+ Voltage Output:	0-400 volts DC, regulated

Current:		0-100 ma continuous, 125 ma intermittent

Regulation:		Output variation less than 1% from no load to full
			load for output of 100 to 400 volts DC. Output
			variation less than +-1% for a +-10% variation
			of the 115 volt or 230 volt AZ input source.

Ripple:			Less than 10 millivolts RMS ripple, jitter and noise.

Output Impedance:	Less than 10 ohms from DC to 1 MHz

C- and Filament Volts Output

C- Voltage Output:	0 to -100 volts DC

Current:		1 ma

Filament Voltage:	6.3 volts AC at 4 amps or 12.6 volts AC at 2 amps
			Note: The 6.3 volt and 12.6 volt outputs may be
			used at the same time provided the total combined
			power does not exceed 25 volt-amps. HV and bias
			can be switched off, leaving filament voltages still
			operative.

General
-------

Output Binding Posts:	Common and + (B+ voltage)
			Common and - (C- voltage)
			6.3 VAC at 4 amps
			12.6 VAC at 2 amps
			Chassis ground

Controls:		AC power switch
			DC On-Standby switch
			Voltmeter switch
			C- volts control
			B+ volts control

Circuit Board Controls:	Zero voltage adjust
			400 volt adjust

Meters
------

Volts - Dual Scale:	0-400 and 0-150 volts DC
			accuracy +- 3% of full scale

Milliampers:		0-150 ma
			accuracy +- 2% of full scale

Tubes:			1 - 6BH6 control amplifier
			1 - 6X4 C- rectifier
			2 - 6L6GC series regulators
			2 - 0A2 voltage regulators
			6 - silicon diodes

Power:			105-125 volts or 210-250 volts
			50/60 Hz AC. 150 watts maximum

Fuse:			1.5 amps (105-125 VAC operation)
			1.0 amps (210-250 VAC operation)

Dimensions:		13 3/8"w x 11 1/4"d x 5 1/2h

Weight:			16 lbs

1968 price:		$59.95