EUW-15 Universal Power Supply The Heathkit model EUW-15 Universal Power Supply serves two purposes; it is both a well regulated power supply for general laboratory applications, and an experimental unit that can provide many different types of power supply circuits. SPECIFICATIONS -------------- B+ Volts Output: Voltage . . . . . . . . . . . . . . . . . 200 to 350 volts DC regulated Current . . . . . . . . . . . . . . . . . 0 to 100 milliamps continuous; 125 milliamps intermittent Filament Voltage Output . . . . . . . . . 6.3 volts AC at 3 amperes B+ Regulation . . . . . . . . . . . . . . Output variation is less than 1% from no load to full load at 300 volts. Output variation is less than +/- 1 volt for a +/- 10 volt variation of the AC line input B+ Ripple . . . . . . . . . . . . . . . . Less than 10 millivolts RMS ripple, jitter and noise B+ Output Impedance . . . . . . . . . . . Less than 10 ohms from 5 – 100,000 Hz Divider Voltages (Unregulated) Approximately 500, 400, 300, 200, and 100 volts Voltage Divider . . . . . . . . . . . . . Internal, using five 1500 ohm 10 watt resistors; also can be used as a variable internal load Variable Load . . . . . . . . . . . . . . Voltage divider can be connected as a variable load, but current must not exceed 80 milliamperes Tube Compliment . . . . . . . . . . . . . 1 - 6L6GC -- series regulator 1 - 6BH6 -- control amplifier 1 - OB2 -- voltage regulator Controls and Switches . . . . . . . . . . DIVIDER VOLTAGE (or variable load switch) DIVIDER-REGULATOR switch REGULATOR VOLTAGE (MIN—MAX) control POWER (ON—OFF) switch HIGH VOLTAGE (ON—OFF) switch PRIMARY VOLTAGE SWITCH (on the chassis) Output Terminals. . . . . . . . . . . . . DC+ and DC- Filament (6.3 VAC) Meter Chassis ground Power Requirements. . . . . . . . . . . . 105 to 125 volts AC, 50/60 Hertz - 85 watts maximum Dimensions. . . . . . . . . . . . . . . . 8-1/4” wide, 12-1/5” deep, 6-1/2” high Net Weight. . . . . . . . . . . . . . . . 13 lbs.